Today CO2 laser engraving machine is a common equipment in the advertising industry. CO2 laser engraving machine can be cut, can also be carved, can also be marked. And the lines of the CO2 laser engraving machine are much thinner than the mechanical engraving machine, and the edges are smoother. Next, introduce the main characteristics of CO2 laser engraving machine.

1, CO2 laser engraving machine has a wide range of applications, can be used for the processing of any non-metallic materials, and the price is cheap.

2, reliable and reliable: the processing of CO2 laser engraving machine is non-contact processing, so it will not cause damage to the material, followed by no "knife marks", the material will not be deformed.

3, environmental protection, low cost: the beam and spot diameter is small, generally less than 0.5mm, the material is very economical when processing.

4, high processing efficiency: CO2 laser engraving machining speed, short delivery cycle.

5, low processing cost: CO2 laser engraving machine is not limited by the number of, can be mass production.

What should be paid attention to when using CO2 laser engraving machine

The laser beam is mainly used to clean the attachment on the surface of the object to be cleaned, which is widely applicable and easy to automatically control. Laser cleaning machine can clean rust, oil, oxide, oxide produced by welding and so on. Next, introduce what you need to pay attention to when using the laser cleaning machine.

We should follow the switching sequence of the laser cleaning machine, turn on the water pump (water cooler), then turn on the power switch, and then turn on the laser switch. Turn off the laser switch first, then turn off the power switch, and then turn off the water pump (water cooler). And every half a month regularly clean the laser machine chiller once, drain the internal water of the machine, and then fill with new pure water. Clean regularly and quantitatively every day, remove debris on the table, stopper and guide rail, and spray lubricating oil on the guide rail.

The mirror and focusing lens of the laser cleaning machine should be scrubbed once every 6-8 hours with a special cleaning solution. When scrubbing, a cotton swab or cotton swab should be dipped in the cleaning solution from the middle of the focusing mirror to the edge in a counterclockwise direction, and care should be taken to prevent scratching the lens of the laser cleaning machine. When the dust is large during processing, it is necessary to clean the fan, open the outer cover of the fan, scrape the dust on the fan blade and the air channel with thin wood chips, and then blow the dust with a high pressure gun. The cleaning method of the smoking pipe is the same as that of the water cleaning method of the pumping fan.