Blog

How to maintain laser equipment?

In the process of using acrylic laser cutting machine, for safety and protection, for efficient production, the vital thing is the routine safety maintenance and care of the equipment. The following describes the maintenance of important parts of the laser machine. Do the following work, so you have unexpected results Oh.

1, linear guide oil filling. Laser cutting machine using a period of cutting smoke, dust generated by the corrosive effect on the guide, so regular maintenance of the guide. The laser cutting machine off the power supply, clean with a clean soft cloth guide clean, and then drip on the guide oil, oil on the slider in the guide to roll back and forth a little to ensure that the lubricant into the slider inside. After the oil in the let the slider in the guide roll back and forth a little, this time shall be the first time to install the guide, pay attention to install the guide do not first fixed, to put all the fixed nails to keep the level, in the belt and the slider fixed, and then the lens installed, dimming a little X go to the way to go finished.

2, reflector, focus mirror wipe. Laser cutting machine after a period of time, smoke will adhere to the surface of the lens, affecting the depth of cut, but also affect the cutting accuracy. Generally in about a week with anhydrous alcohol will be three reflecting mirrors, a focusing mirror carefully wipe clean.

3, bearing oiling. Laser cutting machine uses a large number of bearings, in order to ensure good cutting results, some of the bearings need to be regularly refueled with a clean soft cloth to wipe off the bearing on the floating soil, with a syringe to breathe the oil into the syringe, and then slowly inject the bearing with a needle, slowly rotate the bearing in the oil injection can be.

4, synchronous belt (belt) loosening and tightening adjustment. Laser cutting machine in the transmission system has a number of synchronous belt, if the synchronous belt is too loose, there will be a ghosting situation, if the synchronous belt is too tight, it will cause the synchronous belt wear. After a period of use, please adjust the synchronous belt tensioning screws, the synchronous belt will be adjusted to the right tension.

5, the maintenance of the laser tube. Laser machine in the laser tube is the use of circulating water cooling, long-term use down, there will be some white scale inside the tube, we can add a small amount of vinegar in the circulating water, the tube of water to get rid of, and then use clean water to clean the laser tube internal bad flush, so the laser tube will be in the best working condition, life will also be extended.